SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

Consequence: DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.

NHTSA campaign 09E012000

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE REAR BRAKE LINE ON THE PASSENGER SIDE WAS ROUTED TOO CLOSE TO THE CORNER OF THE FUEL TANK. THE LINE COULD BE DAMAGED BY CHAFING AGAINST THE FUEL TANK.

Consequence: REPEATED CHAFING COULD EVENTUALLY RESULT IN A LEAKING BRAKE LINE CAUSING DIMINISHED BRAKING IN ONE BRAKE CIRCUIT INCREASING THE VEHICLE'S STOPPING DISTANCE.

Remedy: DEALERS WILL INSPECT THE BRAKE LINE AND REPLACE ANY DAMAGED LINES.

NHTSA campaign 98V195000

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE BOLTS SECURING THE FRONT HOOD LATCH CAN LOOSEN OVER TIME. THE LATCH WOULD MOVE CAUSING DISENGAGEMENT OF THE HOOD STRIKER FROM THE LATCH.

Consequence: UNEXPECTED OPENING OF THE HOOD COULD OCCUR OBSTRUCTING THE DRIVER'S VIEW OF THE ROAD WHILE DRIVING, INCREASING THE RISK OF A CRASH.

Remedy: DEALERS WILL INSPECT THE HOOD LATCH AND SECURING BOLTS AND REPLACE THEM IF NECESSARY.

NHTSA campaign 98V160000

IMPROPER MATERIAL WAS USED IN MANUFACTURING THE RADIATOR FAN MOTOR SHAFT CAUSING THE SHAFT TO WEAR AND BECOME NOISY.

Consequence: A WORN AND NOISY FAN MOTOR SHAFT CAN SEIZE RENDERINGTHE FAN MOTOR INOPERATIVE, EVENTUALLY CAUSING THE ENGINE TO OVERHEAT AND STALL. A STALLED VEHICLE IN TRAFFIC CAN INCREASE THE POTENTIAL FOR A VEHICLE ACCIDENT.

Remedy: DEALERS WILL REPLACE THE COMPLETE COOLING FAN ASSEMBLY ON VEHICLE HAVING THE POTENTIAL SHAFT MATERIAL PROBLEM. DEALERS WILL INSTALL A NEW FAN BLADE INCLUDING A NEW LOCK NUT ON VEHICLE WITH LOOSE FAN BLADE LOCK NUTS.

NHTSA campaign 95V178000

WHEN INSTALLED IN THE VEHICLES, A TIE WRAP IS USED TO GUIDE THE CRUISE CONTROL CABLE IN THE ENGINE COMPARTMENT. SOME TIE WRAPS HAVE BEEN INSTALLED WITH A LARGE LOOP OPENING IMPROPERLY GUIDING THE CABLE WHICH COULD PREVENT THE THROTTLE FROM RETURNING TO ITS FULL IDLE POSITION.

Consequence: THE ENGINE SPEED MAY NOT RETURN TO IDLE INCREASING THEPOTENTIAL FOR A VEHICLE COLLISION.

Remedy: DEALERS WILL REMOVE THE CRUISE CONTROL TIE WRAP AND INSTALL A NEWLY DESIGNED GUIDE.

NHTSA campaign 95E034000

THE JACKS SUPPLIED WITH THESE VEHICLES WERE ASSEMBLED WITH AN IMPROPERLY MACHINED SPINDLE, SO THAT A SHARP RIDGE ON THE EDGE OF SPINDLE'S THREAD WOULD HAVE REMAINED.

Consequence: THIS RIDGE CAN DAMAGE THE INSIDE THREAD OF THE JACK'S SCISSOR SHOE WHEN THE JACK IS USED TO LIFT THE VEHICLE. THE JACK COULD COLLAPSE WITH THE POSSIBILITY THAT A PERSON STANDING CLOSE TO THE VEHICLE COULD BE INJURED.

Remedy: OWNERS WILL BE PROVIDED WITH A NEW JACK.

NHTSA campaign 95V054000